|
Lace Frontal Demo
Step:1 Prepare
The first step is to cut the extended lace back to the hairline. Prop the hairpiece on your head for a trial, note where you would like your hairline to began. You should position it along the egde of your natural hairline. Cut the lace until you have your desired hairline. Graudually trim the excess lace, small amounts off at a time. Be careful not to cut any of the hair. Once you are satisfied with the matching of the lace frontal hairpiece and your hairline, trim the lace back to the hairline and match it with your own hairline to ensure a natural appearance.
Step 2: Clean
We recommend preparing the hairline by cleaning it with scalp protector however you may also use rubbing alchol. Oily skin weakens the bond of the adhesives and prevents the strongest hold. Use Scalp Protector around the perimeter of your head to ensure a clean base. An added benefit of the skin protector is that it creates a protective layer between your skin and the glue. Allow the Scalp Protector to dry before applying the glue.
Recommended items for cleaning the hairline:
Rubbing alchhol
Step 3: Adhesive Application (with Ultra Hold)
Use Ultra Hold very sparingly, a little goes a long way. We don’t recommend using the brush that comes with the jar, it provides too much glue at once. Use a small, thin item such as the tail end of a comb or a toothpick to apply the adhesive.
Apply a thin coat of glue around the perimiter. Use a cool blow dryer to for about 30-45 seconds to dry the glue until it's tacky/sticky. Apply a second coat and allow it to get tacky, and gently place the lace frontal hairpiece back onto your head.
Use a blow dryer on cool heat (lowest setting, never hot) to dry the glue until it is a little sticky to the touch. Press the unit and glued area together and apply constant pressure until the unit stays by itself. This may take approx 1 minute.
Recommeded items for application:
Removal
Pull all hair up into a ponytail, to avoid getting adhesive on the hair.
Apply the lace adhesive remover to the adhesive around perimeter of hairline. Let the adhesive remover work for 5 min. Do not pull or tug on the hairpiece. After 5 min the unit should be easily taken off.
Graudually remove the lace, slowly. Be sure not to pull at the lace. Next, shampoo and condition the unit. Let the unit dry naturally, or blow dry or cool/low heat.
Recommended items for removal:
| 
